Pennsylvania Amber Light Laws

(i) less than 75 Pa.C.S. Section 4572(b) means a vehicle registered within the meaning of Section 75 Pa.C.S. Box 102 referred to in Chapter 15 (on approved vehicles and special approvals) may be equipped with flashing or rotating yellow or yellow lights or with one or more luminous bars containing only yellow or yellow lights. See Figure 3.1. Fire truck lighting systems must meet the same standards as police vehicles. Private vehicles used as fire engines must have their lighting systems conforming to 75 Pa.C.S. gather. Section 4571(a). If two or more luminaires are used, they must each have the same colour. Fire trucks are not allowed to use different-colored lighting in Pennsylvania.

For more information, see Pennsylvania Statute §173(a)(5)(ii). Volunteer firefighters are also covered by these laws. (8) Operating lights. Clear or white continuous supply lamps, facing forward or sideways, (i.e. detachable lamps, track lamps, headlamps) shall not be used as a visual signal for the purposes of 75 Pa.C.S. can be used. Chapter 3325. These lights can be used when the vehicle is moving or stationary to ensure an emergency, public safety or law enforcement. Police, Marshall and Sheriff vehicles are all considered authorized emergency vehicles. According to Pennsylvania`s emergency vehicle fire laws, police, Marshall and sheriff vehicles are allowed to use red and blue emergency lights, but also white, yellow and/or yellow warning lights. These are flashing lights.

This is consistent with Section 173.3 of the Pennsylvania Emergency Vehicle Light Statutes. (b) 360° visibility. Except in the case of unmarked police vehicles, the flashing or red, blue, yellow or yellow lights of a vehicle must be equipped with one or more of these lights in order to make visible vehicles approaching from any direction (360° view), regardless of the mode of installation. (iv) Protrusion from wing underway lights near the forward top edge of each forward wing of an emergency vehicle and within 2 inches of the wing. With the high risk of traffic injuries for construction workers, many states allow a variety of warning lights to signal to others that they should slow down. However, there isn`t much information about construction vehicle lighting in Pennsylvania`s emergency vehicle lighting laws. Therefore, it is best to contact the Pennsylvania Department of Transportation to find out what is the correct use of emergency or warning lights. This can save many lives and is your responsibility as an employer and commercial enterprise. (viii) Only with regard to flashing lamps inside the side window of the passenger compartment for non-drivers. The state of Pennsylvania requires emergency vehicles to use warning lights when on public roads.

The type and colour of lights that can be used depends on the type of emergency vehicle you are driving. Below is a general overview of the type of emergency lighting for vehicles that is acceptable, as well as a link to the associated regulations for ease of reference. (f) joining devices. Turn signals or rotating lamps, other than flashing headlamp systems, flashing lamps with calender lamps and intersection lamps, may be fitted to any of the following: The following words and terms, when used in this Chapter, have the following meanings, unless the context indicates otherwise: Vehicle registeredThe term according to 75 Pa.C.S. § 102 (Definitions). Emergency vehicleThe term within the meaning of 75 Pa.C.S. § 102 FlashA burst of intermittent light. The rate of flash, revolution or oscillation per minute of a single light when that light is observed from a fixed position. Flashing light systemA system designed to flash the portion of the main-beam headlamps of a vehicle, alternately or simultaneously. The system shall be so designed that the activation of the high-intensity and high-intensity component of the standard headlamp takes precedence over the indicator system. Flashing LightA light that flashes when the light is cut off or otherwise when the light is observed from a fixed position.

Driver-controlled front and rear flashing lights warn approaching motorists when a vehicle breaks down or is travelling at low speed. Intersection lightA flashing red, blue, white or light light used as part of a flashing, oscillating or rotating lighting system to improve the visibility of a forward and sideways emergency vehicle when approaching or passing through an intersection. Ignition light indicatorAn audible signal or a switch or tell-tale indicating to the driver of a rescue vehicle or an authorized vehicle a clearly audible or visible and continuous indication that an approved flashing or rotating light, flashing light system, traffic safety lamp or non-flashing or non-rotating lamp is illuminated. Light bar assemblyOne or more devices designed and constructed to provide and display more than one continuous hot, flashing, oscillating or rotating light. Oscillating lightA light that flashes as it moves back and forth between two or more points, including alternating between maximum and minimum voltage. Rotating LightLight that gives the appearance of lightning by rotating around a fixed axis through a 360° arc on a horizontal plane. Device comprising one or more lenses, lamps or bulbs designed to produce the appearance of a flashing or rotating light beam from a fixed position or point. Device electronically designed to indicate yellow or yellow warning lights in a pattern of characteristic movement lampsLeft, right, centre or flashing alternately to warn drivers that they are approaching danger or to direct them towards imminent danger. Unmarked police vehicleAn unmarked police vehicle that is not equipped with a roof-mounted light bar.